Grinding mold and mold maintenance method

The steps of grinding the mold

1. First of all, you must be careful when you take the knife, don't bump it, the knife is very sharp, and the blade is easy to damage.

2. Be sure to clamp when installing the tool, and each gripper of the clamp must completely fit the die-cutter.

3. When there is a gap in the die cutter:

The paper discharge knife should be removed first. Then grind the entire mold edge to the full level of the lowest gap. Then sharpen the blade with a grinder. Finally, it is polished by hand with oil stone. Every step here requires experience, and you should try to learn the operation slowly.

4. When the die-cutting knife becomes blunt and there is no gap:

The paper discharge knife should be removed first. Then sharpen the blade with a grinder. Finally, it is polished by hand with oil stone. Every step here requires experience, and you should try to learn the operation slowly.

 

Mold maintenance method

1. When the die-cutting knife becomes blunt and there is no gap:

The paper discharge knife should be removed first. Then sharpen the blade with a grinder. Finally, it is polished by hand with oil stone. Every step here requires experience, and you should try to learn the operation slowly.

 

2. When the die cutter has a gap:

The paper discharge knife must be removed first. Then grind the entire mold edge to the full level of the lowest gap. Then sharpen the blade with a grinder. Finally, it is polished by hand with oil stone. Every step here requires experience, and you should try to learn the operation slowly.

 

3. You must be careful when taking the knife at ordinary times, don't bump it, the knife is very sharp, and the blade is easily damaged by bumping.